What Adapter For
Your answer

Garden hose to 3/4 inch pipe adapter

If the pipe has threads on the outside, use a 3/4" MHT x 3/4" FIP brass adapter. Don’t try the hose on the pipe directly: they’re almost the same width, but hose thread has 11.5 threads per inch and 3/4" pipe thread has 14, so they don’t mesh.

The end that screws onto a faucet, with threads inside and a rubber washer

Male pipe thread (MIP), 1.05" across

What fits

3/4" MHT x 3/4" FIP adapter

On the package: 3/4 in. MHT x 3/4 in. FIP

male hose thread x female pipe thread, brass

Available on Amazon

3/4" MHT x 3/4" FIP brass adapter

As an Amazon Associate, What Adapter For earns from qualifying purchases.

  • One end takes your hose, and the other screws onto the pipe.
  • If the pipe is connected to a water supply, shut the water off first.
  • Wrap thread tape around the pipe’s threads only, the same way the threads spiral (clockwise as you look at the end), starting at the first thread. Don’t tape the hose end. It seals with its rubber washer.

3/4" hose thread and 3/4" pipe thread are almost the same width (1.0625" vs 1.050"), but hose thread has 11.5 threads per inch and pipe thread 14, so the threads don’t mesh. Hose thread is not compatible with other thread systems.

More: Hose thread vs pipe thread

Common questions

What if the 3/4 inch fitting has threads inside?

3/4" MHT x 3/4" MIP adapter. One end takes your hose, and the other screws into the fitting.

How do I connect an outdoor faucet or the male end of a hose to 3/4 inch pipe?

3/4" FHT x 3/4" FIP adapter. One end takes your outdoor faucet or hose male end, and the other screws onto the pipe.

Is garden hose thread 3/4 inch NPT?

No. Garden hose thread (GHT) is sold as 3/4", but it has 11.5 threads per inch and seals with a washer; 3/4" NPT has 14 and seals on its tapered threads with tape or sealant. Count the threads over one inch to tell them apart.

Keep going

Garden hose to 1/2" pipeHose thread vs pipe threadIdentify ithose or pipe thread?Connect two garden hosesGarden hose to drip irrigationConnect different drip tubingToilet supply line size

For a different part on either end, open the adapter finder with this pair picked.

Where we get our information from

The sizes on this page come from published standards and the makers’ own documents. Checked against published data from Swagelok, National Bureau of Standards, Dixon Valve, Anderson Metals and Boshart Industries.

See all 6 sources
  • National Bureau of Standards, Handbook H28 (1957) Part II: Table VII.2 (American Standard taper pipe threads, NPT) and Tables X.1–X.3 (hose coupling threads, NH)
  • Dixon Valve, Technical Information: Identifying Threads and Thread Dimensions (2009 catalog)
  • Swagelok, Thread and End Connection Identification Guide (MS-13-77)
  • Anderson Metals and BrassCraft brass hose adapter listings (FHT x MIP, MHT x FIP and related)
  • Swagelok, Thread Sealants catalog (MS-14-01): PTFE tape, how to apply
  • Boshart Industries, “How to Apply PTFE Thread Seal Tape”

General guidance from manufacturer and standards data. Parts vary by brand, so check the size printed on the package against what you measured. For gas lines or anything inside a wall, use a licensed plumber.